Technical drawings. General principles of presentation - Basic conventions for cuts and sections Ingestion-build-82396 The purpose of BS EN

The purpose of BS EN IEC 60966-1 is to give general procedures on how to achieve quality management for radiofrequency cable assemblies

It utilizes the test method of IEC 60068-2-61

Short-term test with alternate wetting with water and drying in warm air

interactive terminals

This technology is mainly intended for use with simple sensors and actuators in factory automation

Technical drawings. General principles of presentation - Basic conventions for cuts and sections Ingestion-build-82396 The purpose of BS EN1 Scope This part of ISO 128 specifies the general principles for presenting cuts and sections applicable to all kinds of technical drawings (mechanical, electrical, architectural, civil engineering, etc.) following the orthographic projection methods specified in ISO 5456 2. For areas on cuts and sections, representation is according to ISO 128 50. Attention has also been given in this part of ISO 128 to the requirements of reproduction, including