Specification for high expansion heat-resisting steel bar and wire for the manufacture of bolts, studs, set screws and nuts (Ni 25.5, Cr 15, Ti 2, Mn 1.5, Mo 1.25, Si 0.7, V 0.3) (limiting ruling section 50 mm) Ingestion-build-225643 Identifying interoperable combinations of subsystems

Identifying interoperable combinations of subsystems

operating at rates of 100 kilobits/second or less

1 specifies the test procedures for discrete semiconductor devices

as a document

Test piece and arrangement of electrodes for measurement of resistivity of the conductor screen

Specification for high expansion heat-resisting steel bar and wire for the manufacture of bolts, studs, set screws and nuts (Ni 25.5, Cr 15, Ti 2, Mn 1.5, Mo 1.25, Si 0.7, V 0.3) (limiting ruling section 50 mm) Ingestion-build-225643 Identifying interoperable combinations of subsystems1 Scope This British Standard specifies requirements for high expansion heat resisting steel bar and wire in the following forms for the manufacture of bolts, studs, set screws and nuts. a) Bar with a diameter over 25 mm up to and including 50 mm and wire with a maximum diameter of 50 mm for machining: softened, cold worked, solution treated and machined or ground, designation HR 650A. b) Bar with a diameter over 25 mm up to and including 50 mm and